Table of Contents
Advertisement
Chapter 3: Client, Host, and MDIO Interfaces
All bit fields for the EMAC#CLIENTRXSTATS[6:0] are valid only when the
EMAC#CLIENTRXSTATSVLD is asserted as illustrated in
EMAC#CLIENTRXSTATSBYTEVLD is asserted if an Ethernet MAC frame byte (DA to
FCS inclusive) is received. This is valid on every CLIENTEMAC#RXCLIENTCLKIN cycle.
CLIENTEMAC#RXCLIENTCLKIN
EMAC#CLIENTRXD[7:0]
EMAC#CLIENTRXDVLD
EMAC#CLIENTRXDVLDMSW
EMAC#CLIENTRXGOODFRAME
EMAC#CLIENTRXSTATSBYTEVLD
EMAC#CLIENTRXSTATSVLD
EMAC#CLIENTRXSTATS[6:0]
Table 3-5: Bit Definitions for the Receiver Statistics Vector
RX_STATISTICS_VECTOR
26
25
24
www.BDTIC.com/XILINX
70
DA
Figure 3-37: Receiver Statistics Vector Timing
Name
ALIGNMENT_ERROR
Length/Type Out of Range
BAD_OPCODE
www.xilinx.com
Figure
SA
L/T
DATA
Description
Used in 10/100 MII mode. If an odd number of nibbles
is received, the last nibble is ignored. If the frame
without this nibble has an incorrect FCS, this bit is
asserted. If the frame has a valid FCS, this bit is not
asserted.
Asserted if the LT field contains a length value that
does not match the number of Ethernet MAC client
data bytes received. Also asserted High if the LT field
indicates that the frame contains padding but the
number of Ethernet MAC client data bytes received is
not equal to 46 bytes (minimum frame size).
Asserted if the previous frame is error free, contains the
special control frame identifier in the LT field, but
contains an OPCODE unsupported by the Ethernet
MAC (any OPCODE other than PAUSE).
Embedded Tri-Mode Ethernet MAC User Guide
UG074 (v2.2) February 22, 2010
R
3-37.
[6:0]
[26:21]
ug074_3_39_010906
Advertisement
Table of Contents
