3: System Operation; Introduction; Power Switch - Horiba Scientific FluoroMax-4 Operation Manual

® ®
FluoroMax -4 & FluoroMax -4P with USB rev. D (30 Jul 2012)

3: System Operation

Introduction

This chapter explains how to turn on the FluoroMax
and, if necessary, recalibrate the monochromators. While doing these procedures, how
to define a scan, run a scan, and optimize system settings to obtain the best results is
explained.

Power switch

The power switch is located on the lower right-hand side of the instrument. When
switched on, the xenon lamp arcs initially, and the FluoroMax
through self-diagnostics, then starts the xenon lamp.
Note:
riods of inactivity.
HORIBA Scientific suggests leaving the lamp on during brief pe-
®
-4 system, check its calibration,
®
-4 turns on, runs
3-1
System Operation