Horiba Scientific FluoroMax-4 Operation Manual page 171

® ®
FluoroMax -4 & FluoroMax -4P with USB rev. D (30 Jul 2012)
Subtract Dark (recommended)
Reset to Mechanical Zero—only if the polarizers are definitely miscalibrated.
This deletes the previous calibration.
Note:
5
Place the Ludox
holder.
6
Click the
Continue
button.
The system rotates through the po-
larizers as shown in the checklist on the window. As each phase is completed,
the checkboxes are up-
dated. If the sample is too
concentrated or dilute,
the software prompts you
to correct this.
Do not check the Remeasure Anisotropy Only checkbox.
®
or glycogen in the sample
Caution:
Refer to your Material
Safety Data Sheets (MSDS)
for hazards regarding the use
of glycogen or colloidal silica.
10-11
Automated Polarizers