Categorization According To The + Code; Contents - ABB ACS800-U1 Hardware Manual

16 Introduction to this manual

Categorization according to the + code

The instructions, technical data and dimensional drawings that concern specific
optional selections are marked with + codes, for example, +E202. You can identify
the options in the drive from the + codes on the type designation label. The + code
Type code
selections are listed in (page 23).

Contents

A brief description of the chapters in this manual:
Safety instructions
(page 15) give safety instructions for the installation,
commissioning, operation and maintenance of the drive.
Introduction to this manual
(page 15) lists the steps to check the delivery and install
and commission the drive and refers to chapters/sections in this manual and other
manuals.
Operation principle and hardware description
(page 21) describes the drive.
Mechanical installation
(page 27) instructs how to place and mount the drive.
Planning the electrical installation
(page 35) instructs on the motor and cable
selection, protections and cable routing.
Electrical installation
(page 59) shows how to wire the drive.
Installation of the AGPS board (Prevention of unexpected start-up, +Q950)
(page 75)
contains electrical installation instructions of the optional Prevention of unexpected
start-up function (+Q950) of the drive, and gives instructions for start up, validation
and use.
Installation of the ASTO board (Safe torque off, +Q967)
(page 81) describes the
electrical installation of the optional Safe torque off function (+Q967).
Motor control and I/O board (RMIO)
(page 85) shows the external control
connections to the I/O board.
Installation checklist
(page 93) contains a list for checking the mechanical and
electrical installation of the drive.
Start-up and use
(page 95) describes the start-up procedure and use of the drive.
Maintenance
(page 97) contains preventive maintenance instructions.
Technical data
(page 105) contains the technical specifications of the drive: The
ratings, sizes and technical requirements, provisions for fulfilling the requirements
for CE and other markings and warranty policy.
Dimensional drawings
(page 133) contains the dimensional drawings of the drive.
Resistor braking
(page 161) describes how to select, protect and wire brake
choppers and resistors. The chapter also contains the relevant technical data.
External +24 V DC power supply for the RMIO board via terminal X34
(page 169)
describes how to connect an external +24 V DC power supply for the RMIO board
using terminal X34.
RDCO-01/02/03/04 DDCS communication option modules
(page 173) has a
description of the RDCO-0x DDCS communication option module connections and
the technical specifications of the RDCO-0x modules.