Quick installation and start-up
instructions
Contents of this chapter
This chapter tells you briefly how to install the drive module into a cabinet. For more
detailed instructions, engineering guide lines, technical data and complete safety
instructions, see the hardware manual
Obey the safety instructions
General safety
■
These instructions are for all personnel who do work on the drive.
WARNING!
Obey these instructions. If you ignore them, injury or death, or damage to the
equipment can occur.
•
Keep the drive in its package until you install it. After unpacking, protect the drive
from dust, debris and moisture.
•
Use the required personal protective equipment: safety shoes with metal toe cap,
safety glasses, protective gloves and long sleeves, etc. Some parts have sharp
edges.
•
Lift a heavy drive with a lifting device. Use the designated lifting points.
•
Obey the local laws and regulations applicable to lifting, such as requirements for
planning the lifting, for capacity and condition of lifting equipment, and for training
of personnel.
•
Attach the drive cabinet to the floor to prevent it from falling over. The cabinet
has a high center of gravity. Attach the cabinet also to the wall when necessary.
•
Do not do work on the drive when a rotating permanent magnet motor is
connected to it. A rotating permanent magnet motor energizes the drive, including
its input and output terminals.
•
Make sure that debris from drilling, cutting and grinding does not enter the drive.
Quick installation and start-up instructions 7
3AXD50000034664
[English]).