Subaru IMPREZA GD 2007 Series Manual page 1714

asieps_tobira_IM_US.book 15 ページ ２０１２年１月１７日 火曜日 午後３時４８分
5. Rear Exhaust Pipe
A: REMOVAL
CAUTION:
Be careful not to burn yourself, because the ex-
haust pipe becomes extremely hot after run-
ning.
1) Set the vehicle on a lift.
2) Lift up the vehicle.
3) Separate the rear exhaust pipe from center ex-
haust pipe.
4) Separate the rear exhaust pipe from muffler.
CAUTION:
Be careful not to pull down the rear exhaust
pipe.
5) Apply a coat of spray type lubricant to the mating
area of cushion rubber.
6) Remove the rear exhaust pipe from the cushion
rubber.
7) Remove the rear exhaust pipe.
Rear Exhaust Pipe
B: INSTALLATION
1) Apply a coat of spray type lubricant to the mating
area of cushion rubber.
2) Install the rear exhaust pipe bracket to cushion
rubber.
NOTE:
After assembling, degrease the lubricant which
was applied to the cushion rubber while removing/
installing.
3) Install the rear exhaust pipe to muffler.
EX-02091
NOTE:
Use a new gasket and self-locking nut.
Tightening torque:
48 N·m (4.9 kgf-m, 35.4 ft-lb)
EX-00020
4) Install the rear exhaust pipe to center exhaust
pipe.
NOTE:
Use a new gasket.
Tightening torque:
18 N·m (1.8 kgf-m, 13 ft-lb)
EX-02126
5) Lower the vehicle.
EX(H4DOTC)-15
EXHAUST
EX-02126
EX-00020
EX-02091