asieps_tobira_IM_US.book 322 ページ 2012年1月17日 火曜日 午後3時48分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
ENGINE (DIAGNOSTICS)
Step
20
CHECK HARNESS BETWEEN ECM AND
REAR OXYGEN SENSOR CONNECTOR.
1) Connect the connector to ECM.
2) Turn the ignition switch to ON.
3) Measure the voltage between rear oxygen
sensor connector and chassis ground.
Connector & terminal
(T6) No. 3 (+) — Chassis ground (–):
Check
Is the voltage 0.2 — 0.5 V?
EN(STI)(diag)-322
Yes
No
Replace the rear
Repair the harness
oxygen sensor.
and connector.
<Ref. to
NOTE:
FU(H4DOTC)-48,
In this case, repair
Rear Oxygen Sen-
the following item:
sor.>
• Open circuit of
harness between
the ECM and rear
oxygen sensor
• Poor contact in
ECM connector
• Poor contact of
coupling connector