asieps_tobira_IM_US.book 269 ページ 2012年1月17日 火曜日 午後3時48分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step
1
CHECK HARNESS BETWEEN ECM AND
SECONDARY AIR PUMP RELAY.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from the ECM
and secondary air pump relay.
3) Measure the voltage between ECM and
chassis ground.
Connector & terminal
(B136) No. 8 (+) — Chassis ground (–):
Check
Is the voltage 10 V or more?
EN(STI)(diag)-269
ENGINE (DIAGNOSTICS)
Yes
No
Repair the short
Even if the malfunc-
circuit to power in
tion indicator light
the harness
illuminates, the cir-
between ECM and
cuit has returned to
secondary air
a normal condition
pump relay.
at this time. Repro-
duce the fault con-
dition, and
reperform the
check.
NOTE:
In this case, there
may be a tempo-
rary connector
contact failure.