Subaru IMPREZA GD 2007 Series Manual page 1708

asieps_tobira_IM_US.book 9 ページ ２０１２年１月１７日 火曜日 午後３時４８分
2) Install the front exhaust pipe cover.
Tightening torque:
Except for STI model
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
STI model
25 N·m (2.5 kgf-m, 18.1 ft-lb)
3) Install the exhaust manifold upper cover (RH).
Tightening torque:
19 N·m (1.9 kgf-m, 14.0 ft-lb)
4) Install the front exhaust pipe assembly.
NOTE:
Use a new gasket.
Tightening torque:
35 N·m (3.6 kgf-m, 26 ft-lb)
5) Connect the exhaust manifold (RH) to turbo-
charger joint pipe.
NOTE:
Use a new gasket.
• Except for STI model
Tightening torque:
T1: 35 N·m (3.6 kgf-m, 26 ft-lb)
T2: 40 N·m (4 kgf-m, 28.9 ft-lb)
T1
T2
Front Exhaust Pipe
• STI model
Tightening torque:
35 N·m (3.6 kgf-m, 26 ft-lb)
6) Install the exhaust manifold lower cover (RH)
and the exhaust manifold cover (LH).
Tightening torque:
19 N·m (1.9 kgf-m, 14.0 ft-lb)
7) Install the front oxygen (A/F) sensor. <Ref. to
T2
FU(H4DOTC)-46, INSTALLATION, Front Oxygen
(A/F) Sensor.>
8) Install the under cover.
9) Connect the ground cable to the battery.
EX-00070
T2
EX-00071 C: INSPECTION
1) Check the connections and welds for exhaust
leaks.
2) Make sure there are no holes or rusting.
EX(H4DOTC)-9
EXHAUST
EX-00132
EX-02057
FU-00009