Subaru IMPREZA GD 2007 Series Manual page 1535

asieps_tobira_IM_US.book 204 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
ENGINE (DIAGNOSTICS)
Step
1 CHECK OUTPUT SIGNAL OF ECM.
1) Turn the ignition switch to ON.
2) Measure the voltage between ECM and
chassis ground.
Connector & terminal
(B136) No. 17 (+) — Chassis ground (–):
2 CHECK HARNESS BETWEEN ECM AND
DRAIN VALVE.
1) Turn the ignition switch to OFF.
2) Disconnect the connectors from the ECM
and drain valve.
3) Measure the resistance between the drain
valve connector and chassis ground.
Connector & terminal
(R69) No. 2 — Chassis ground:
3 CHECK HARNESS BETWEEN ECM AND
DRAIN VALVE.
Measure the resistance of harness between
ECM and drain valve connector.
Connector & terminal
(B136) No. 17 — (R69) No. 2:
4 CHECK DRAIN VALVE.
Measure the resistance between drain valve
terminals.
Terminals
No. 1 — No. 2:
5 CHECK POWER SUPPLY TO DRAIN VALVE.
1) Turn the ignition switch to ON.
2) Measure the voltage between drain valve
and chassis ground.
Connector & terminal
(R69) No. 1 (+) — Chassis ground (–):
Check
Is the voltage 10 V or more?
Is the resistance 1 MΩ or more? Go to step 3.
Is the resistance less than 1 Ω? Go to step 4.
Is the resistance between 10 —
100 Ω?
Is the voltage 10 V or more?
EN(STI)(diag)-204
Yes No
Repair poor con- Go to step 2.
tact of the ECM
connector.
Repair the ground
short circuit of har-
ness between
ECM and drain
valve connector.
Repair the harness
and connector.
NOTE:
In this case, repair
the following item:
• Open circuit of
harness between
ECM and drain
valve connector
• Poor contact of
coupling connector
Go to step 5.
Replace the drain
valve. <Ref. to
EC(H4DOTC)-20,
Drain Valve.>
Repair the poor Repair the harness
contact of drain and connector.
valve connector.
NOTE:
In this case, repair
the following item:
• Open circuit of
harness between
main relay and
drain valve
• Poor contact of
coupling connector
• Poor contact of
main relay connec-
tor