asieps_tobira_IM_US.book 66 ページ 2012年1月17日 火曜日 午後3時48分
FUEL INJECTION (FUEL SYSTEMS)
28.Fuel Sub Level Sensor
A: REMOVAL
WARNING:
Place "NO OPEN FLAMES" signs near the
working area.
CAUTION:
Be careful not to spill fuel.
1) Set the vehicle on a lift.
2) Disconnect the ground cable from the battery.
3) Lift up the vehicle.
4) Drain the fuel tank. <Ref. to FU(H4DOTC)-55,
DRAINING FUEL, PROCEDURE, Fuel.>
5) Remove the trunk room mat. (Sedan model)
6) Remove the luggage floor mat. (Wagon model)
<Ref. to EI-61, REMOVAL, Luggage Floor Mat.>
7) Remove the service hole cover.
8) Disconnect the connector from the fuel sub level
sensor.
9) Disconnect the fuel jet pump hose.
Fuel Sub Level Sensor
10) Remove the bolts which install fuel sub level
sensor on fuel tank.
11) Remove the fuel sub level sensor.
FU-00009
B: INSTALLATION
Install in the reverse order of removal while being
careful of the following.
• Make sure the sealing portion is free from fuel or
foreign matter before installation.
• Tighten the nuts to the specified torque in the or-
der as shown in the figure.
NOTE:
Use a new gasket.
Tightening torque:
4.4 N·m (0.45 kgf-m, 3.3 ft-lb)
FU-00113
FU-00114
FU(H4DOTC)-66
FU-00115
FU-00116
3
1
5
6
2
4
FU-01145