Subaru IMPREZA GD 2007 Series Manual page 1743

asieps_tobira_IM_US.book 26 ページ ２０１２年１月１７日 火曜日 午後３時４８分
FUEL INJECTION (FUEL SYSTEMS)
19) Remove the tumble generator assembly from
intake manifold.
D: ASSEMBLY
NOTE:
Use a new gasket.
1) Install the tumble generator valve assembly onto
intake manifold.
Tightening torque:
8.25 N·m (0.84 kgf-m, 6.1 ft-lb)
2) Install the air intake duct to the intake manifold.
Tightening torque:
19 N·m (1.94 kgf-m, 14.0 ft-lb)
Intake Manifold
3) Install the fuel pipe assembly and pressure reg-
ulator to intake manifold.
Tightening torque:
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
FU-00053
4) Install the fuel injector pipe LH.
5) Connect the fuel hose LH to the injector pipe,
and tighten the clamp screw.
Tightening torque:
1.25 N·m (0.13 kgf-m, 0.94 ft-lb)
FU-00053
6) Install the fuel injector pipe RH.
7) Connect the fuel hose RH to the fuel injector
pipe, and tighten the clamp screw.
Tightening torque:
1.25 N·m (0.13 kgf-m, 0.94 ft-lb)
FU-01076
8) Install the engine harness to the intake manifold.
FU(H4DOTC)-26
FU-00051
FU-02760
FU-01051