Table of Contents
Advertisement
NOTE
The TPA is fragile and may break if not done
carefully.
View of the male half of the connector with female
terminals.
View of the female half of the connector with male
terminals.
3. Use the J 38125-215 tool to release the terminals by
inserting the tool into the terminal release cavity. See
the release tool cross reference in the Reference
Guide of the J-38125 to ensure that the correct
release tool is used.
View of the female half of the connector with male
terminals.
View of the male half of the connector with female
terminals.
4. While holding the removal tool in place, gently pull
the wire out of the back of the connector. Always
remember never use force when pulling a terminal
out of a connector.
Repair Procedure
Use the appropriate terminal and follow the instructions
in the J-38125.
Location of the terminal in the repair tray and the proper
crimp tool can be found in the appropriate connector end
view.
Wiring Systems:
9A-207
Advertisement
Table of Contents
Troubleshooting
