Installation Procedure
1. Install the relay (2) in the same position as removed.
2. Install the electrical center cover.
Relay Replacement (Attached to Wire
Harness)
Removal Procedure
1. Locate the relay. Refer to the "Master Electrical
Component List" to locate the relay in the vehicle.
2. Remove any fasteners which hold the relay in place.
3. Remove any connector position assurance (CPA)
devices or secondary locks.
NOTE
Use care when removing a relay in a wiring
harness when the relay is secured by
fasteners or tape.
4. Separate the relay (1) from the wire harness
connector (2).
Installation Procedure
1. Connect the relay (1) to the wire harness connector
(2).
2. Install any connector position assurance (CPA)
devices or secondary locks.
3. Install the relay using any fasteners or tape that
originally held the relay in place.
Wiring Systems:
9A-209