Front Door Glass - Subaru Impreza 2003 Service Manual

B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
Make sure the glass stay is placed securely in
sash.
2) Adjust the front door glass. <Ref. to GW-11, AD-
JUSTMENT, Front Door Glass.>
Tightening torque:
Refer to COMPONENT in General Descrip-
tion. <Ref. to GW-4, FRONT DOOR GLASS,
COMPONENT, General Description.>
C: ADJUSTMENT
NOTE:
Before adjustment, ensure that all adjusting bolts of
stabilizer, upper stopper, and sash are loosened
and door glass is raised so that it is in contact with
weather strip.
1) Temporarily tighten one adjusting bolt on one
side of rear sash at the midpoint of slotted hole in
the inner panel.
2) Temporarily tighten the regulator B-channel in a
position at the top of slotted hole.
3) Lower the door glass 10 to 15 mm (0.39 to 0.59
in) from fully closed position. While applying out-
ward pressure of 45.0±5.0 N (4.5±0.5 kgf, 9.9±1.1
lb) (F) to upper edge of glass above midpoint of two
outer stabilizers, press the inner stabilizer at pres-
sure of 30±5 N (3.0±0.5 kgf, 6.6±1.1 lb) to the
glass, then secure it.
(1)
(2)
(1) Full close position
(2) Stabilizer
(3) 10 — 15 mm (0.39 — 0.59 in)

FRONT DOOR GLASS

F
(3)
A A
(2)
A = A
GW-00063
4) For adjustment of clearance between front glass
and center pillar cover, loosen the nuts (A), and
move the glass sash back and forward until clear-
ance becomes the value shown.
(1) 12 mm (0.472 in)
5) For adjustment of upper and lower ends of cen-
ter pillar, loosen the adjusting nut (A) of B-channel
(B).
GW-11
GLASS/WINDOWS/MIRRORS
(A)
GW-00216
(1)
A A
A-A
GW-00064
(B)
(A)
GW-00092
(1)
BO0388