Subaru Impreza 2003 Service Manual page 3023

B: INSTALLATION
1) Install in the reverse order of removal.
NOTE:
Make sure the glass stay is placed securely in
sash.
2) Adjust the rear door glass. <Ref. to GW-23, AD-
JUSTMENT, Rear Door Glass.>
Tightening torque:
Refer to COMPONENT in General Descrip-
tion. <Ref. to GW-5, REAR DOOR GLASS,
COMPONENT, General Description.>
C: ADJUSTMENT
NOTE:
The rear door glass, as a rule, should be adjusted
in the same manner as front glass, although they
are different in dimension. Special notes for the
rear glass are given below.
1) Adjust the glass position using the following di-
mensions as a guide line.
A A
(1) 12 mm (0.472 in)
NOTE:
• If the dimensions are smaller than the given di-
mensions, glass may get caught in weather strip
during lifting/lowering operation. In the worst case,
it may cause the glass not to be opened fully.
• After adjustment, move the glass up and down to
check whether it is caught.
REAR DOOR GLASS
(1) (1)
A-A
GW-00067
2) Adjust the contact degree of glass using the fol-
lowing dimensions as a guide line.
A
A
(1) 2 — 3 mm (0.079 — 0.118 in)
(2) 6 mm (0.236 in)
NOTE:
• If the contact degree of rear glass is higher than
necessary, glass may get caught in weather strip of
center pillar corner, resulting in early wear of
weather strip. Be careful when adjusting.
• After adjustment, move the glass up and down to
check whether it is caught.
GW-23
GLASS/WINDOWS/MIRRORS
(1)
(2)
A-A
GW-00233