Subaru Impreza 2003 Service Manual page 2920

SEAT BELT SYSTEM
5. Front Seat Belt
A: REMOVAL
1. FRONT OUTER BELT
1) Turn the ignition switch to OFF, disconnect the
ground cable from battery, and wait for more than
20 seconds before starting work.
2) Fold backrest all the way forward, and then
move front seat all the way forward.
3) Remove the center pillar lower trim. <Ref. to EI-
47, REMOVAL, Lower Inner Trim.>
4) Remove the anchor cover. Loosen the shoulder
anchor bolt, and then detach the shoulder anchor
from center pillar.
5) Turn over the floor mat to disconnect the con-
nector (A) of pretensioner, and then loosen the
three bolts to remove the front outer belt.
6) Remove the center pillar upper trim. <Ref. to EI-
46, REMOVAL, Upper Inner Trim.>
FRONT SEAT BELT
7) Remove the two bolts and adjustable anchor as-
sembly.
CAUTION:
• Do not drop or apply any impact to the pre-
tensioner.
• Pretensioner and bracket should be treated
as an assembly. Do not attempt to disassemble
it.
2. FRONT INNER BELT
1) Turn the ignition switch to OFF, disconnect the
ground cable from battery, and wait for more than
20 seconds before starting work.
2) Remove the console box. <Ref. to EI-42, RE-
SB-00003
MOVAL, Console Box.>
3) Disconnect the seat belt warning light connector
under the seat.
4) Remove the clip of harness from seat rail.
5) Remove the anchor bolt, and then remove the
inner belt.
(A)
SB-00134
SB-12
SB-00117
SB-00006