Table of Contents
Advertisement
2.5 Replacing the front spar
17. Using the front cross-member as a template for
drilling, drill the specified holes in the spar and then
fasten the spar to the cross-member with 6 structural
rivets (Ø 6.4).
18. Refit the front cross-member (see chapter 2.4).
19. Refit the front trellis (see chapter 2.3).
20. Refit the fender mounting (see chapter 2.2).
Refit the fender, bumper and lid.
Check the clearance dimensions, rework if necessary.
Remove the fender, bumper and lid for subsequent
painting.
Copyright ©
2010
17
Advertisement
Table of Contents
