Table of Contents
Advertisement
Suspension arms
Using a delible yellow marker pen or paint, make
reference markings on the stud bolts and relative
nuts and the eyebolts of the Flanblocs fastening
the lower arm.
DO NOT use lubricants or electric/pneumatic
drivers.
Partially loosen the four nuts fastening the lower
arm (A), retrieving the four shims (5), in the
following order: (a), (b), (c), (d).
Check that the yellow reference markings are
correctly aligned: the marking on the stud bolts
and the marking on the Flanbloc eyebolts must
be aligned.
Only the nut must turn, the stud bolt must remain
in its original position.
If the markings on the stud bolts and eyebolts are
not correctly aligned after loosening the arm
fastener nuts (even if only on one stud bolt), a
ROL (Red On Line) must be opened, attaching
adequate photographic documentation, and
contact the Ferrari Help Desk.
If the markings on the stud bolts and eyebolts are
correctly aligned after loosening the arm fastener
nuts, completely undo and remove the four arm
fastener nuts in the order given for the previous
operation.
Page 7 of 24
Advertisement
Table of Contents
