Table of Contents
Advertisement
Suspension arms
Remove the toe-in tie-rod from the relative seat.
Refitting the toe-in tie-rods
Tightening torque
Fastening toe-in tie-rod to hub carrier
Fastening toe-in tie-rod to chassis
Check that the yellow reference markings are
correctly aligned: the marking on the threaded
rods and the marking on the eyebolts must be
aligned.
Only the nut must turn, the threaded rod must
remain in its original position.
If the markings on the threaded rods and eyebolts
are not correctly aligned after loosening the toe-
in tie rod fastener nuts (even if only on one
threaded rod), a ROL (Red On Line) must be
opened, attaching adequate photographic
documentation, and contact the Ferrari Help
Desk.
If the markings on the threaded rods and eyebolts
are correctly aligned after loosening the toe-in tie-
rod fastener nuts, completely undo and remove
the two toe-in tie-rod fastener nuts.
Check again that the yellow reference markings are
correctly aligned: the markings on the threaded
rods and the markings on the eyebolts must be
aligned.
Nut
Nut (pretightening)
Nut
Page 22 of 24
Nm
Class
80 Nm
A
9 Nm
B
60 Nm
A
Advertisement
Table of Contents
