Table of Contents
Advertisement
Removing the complete engine
Using a mobile hydraulic hoist with a minimum load
capacity of 300 Kg, position the lift hook over the
engine.
Use a suitable strap (39) to fasten the hook
(AV
3979) to the hoist.
Using two suitably sized straps (41) and carabiners,
connect the hook
(AV
3979) to the brackets
(AV
8252) fastened previously to the exhaust
stud bolts.
Using a suitably sized strap (42) and carabiners,
connect the lift tool
(AV
previously onto the crankcase stud bolts to the
hydraulic hoist.
Tauten the hoist straps with the mobile hydraulic
hoist.
Remove the block (F) fitted previously.
On both sides, undo the screws (42) fastening the
engine strut to the engine mounting bush,
retrieving the relative washer.
Lift the engine by a few millimetres, ensuring that
the strap tension is uniform and that the engine
itself lifts evenly.
On the right-hand side only (as shown in the photo
aside), undo the screws indicated and remove
the engine mounting bush (43), to allow enough
room for the engine to be lifted past the oil pump.
Retrieve the retainer bracket (44).
Page 16 of 26
3432) mounted
Advertisement
Table of Contents
