Table of Contents
Advertisement
Complete suspension
Remove the complete rear suspension from the vehicle, retrieving the two washers of upper lever stud bolts.
Detach the tie-rod (15) for the NRRPS motion
sensor from the lower arm (F).
DO NOT use lubricants or electric/pneumatic
drivers.
Partially loosen the four nuts indicated fastening the
lower arm (F) to the chassis, retrieving the four
shims (16), in the following order: (a), (b), (c), (d).
Check that the yellow reference markings are
correctly aligned: the marking on the threaded
rods and the marking on the Flanbloc eyebolts
must be aligned.
Only the nut must turn, the threaded rod must
remain in its original position.
If the markings on the threaded rods and Flanbloc
eyebolts are not correctly aligned after loosening
the arm fastener nuts (even if only on one
threaded rod), a ROL (Red On Line) must be
opened, attaching adequate photographic
documentation, and contact the Ferrari Help
Desk.
If the markings on the threaded rods and Flanbloc
eyebolts are correctly aligned after loosening the
arm fastener nuts, completely undo and remove
the four arm fastener nuts in the order given for
the previous operation.
Check again that the yellow reference markings are
correctly aligned: the markings on the threaded
rods and the markings on the Flanbloc eyebolts
must be aligned.
Page 18 of 25
Advertisement
Table of Contents
