Vehicle Set-Up; Checks And Preparation Of Vehicle; Front Set-Up Data; Rear Set-Up Data - Ferrari 458 Italia Technical Documentation Manual

Vehicle set-up

Print Exit
D4.07 Vehicle set-up

Checks and preparation of vehicle

Check the following before inspecting the set-up:
Wheel fastening;
Tyre pressure;
Clearance between pinion and rack in steering system;
Clearance between ball studs and steering tie-rods;
State of the shock absorbers;
Clearance between hub carriers and ball joints.
Set the vehicle on a flat surface and "filled with the correct quantities of fluids" with a full tank of fuel and the
electric parking brake activated.
Toe-in is measured over a diameter of 495 mm.
The following set-up data is relative to the car WITHOUT SAND BAGS.

Front set-up data

Adjusted vehicle 139.4±5 mm
height
Wheel camber -0.73° ± 0.2°
Caster 4.6°±0.4°

Rear set-up data

Adjusted vehicle 165.8±5 mm
height
Wheel camber -1.31° ± 0.2°
Caster 2.28° ± 0.4°
Toe-in
Total On wheel
Page 1 of 4