Table of Contents
Advertisement
3.5 Replacing the sill
2. Cut the sill near the weld beads joining to the torque
box, the upper diagonal brace, the fuel tank cross-
member and the semi-floorpan.
Caution!
Work with the utmost caution to prevent damaging
the internal diagonal braces connected to the
centre tunnel, the upper diagonal brace and the
torque box.
3. Remove the structural fastener rivets joining the sill
and the semi-floorpan.
NOTE!
Retrieve all the rivets, using a magnet if
necessary, as any remaining rivets will cause
noise when the vehicle is in use.
Copyright ©
2010
2
2
2
2
3
3
2
Advertisement
Table of Contents
