Table of Contents
Advertisement
4.5 Replacing the flank mounting bracket
9. Fit the connector bracket (A) and tack in position.
Check that the assembly is correctly positioned and
adjust if necessary.
10. Weld the flank mounting bracket to the rear spar at
the original weld points.
Caution!
When welding the flank mounting bracket, there
is a risk of the spar (B) buckling as a result of
the heat.
To prevent this, the bracket must only be welded
with the rear cross-member mounted in the jig
(see chapter 4.2).
Copyright ©
2010
9
9
B
10
10
10
A
Advertisement
Table of Contents
