Table of Contents
Advertisement
Brake discs
Refit the front brake callipers (
Refit the rear brake callipers (
Fill and bleed the brake system (
Carry out this operation only if the oil pipe unions have been disconnected.
Refit the wheels (
D2.01).
Only in the case of replacing the discs. Bed in the CCM pads (
Fit the disc on the wheel bearing.
To centre the disc on the wheel bearing, hand
Tighten the screw (2) fastening the disc.
Tightening torque
Screw
Tighten the wheel locator pin (1).
Tightening torque
Pin
Remove the stud bolts fitted previously for aligning
D3.05).
D3.05).
D3.10).
tighten the wheel fastener stud bolts into their
seats.
the disc.
D3.04).
Page 2 of 2
Nm
Class
15.5 Nm
B
Nm
Class
15.5 Nm
B
Advertisement
Table of Contents
