Table of Contents
Advertisement
3.6 Replacing the rear firewall and mountings
7. Remove the structural fastener rivets joining the
firewall and the relative mountings.
NOTE!
Retrieve all the rivets, using a magnet if
necessary, as any remaining rivets will cause
noise when the vehicle is in use.
8. Sand the joint weld beads between the RH and LH
firewall mountings and the rear sill pillars.
Caution!
Check that the rear sill pillar casting joints are
free from cracks or buckling.
If any damage is noted, replace the sill (see
chapter 3.5).
Copyright ©
2010
7
8
8
7
Advertisement
Table of Contents
