After topping up, the "Low oil level" symbol shown aside may remain active on the left hand TFT display for a prolonged period of time. This occurs to

allow the system to perform all the checks necessary. This is completely normal.

9. After adding or replacing oil, check the oil level again using the procedure described above.

Draining the engine lubrication system

Pour the oil drained from the system into a container and seal it. DO NOT dispose of used oil in the environment.

Remove the rear flat undertray section (

Replacing the engine oil filter

Tightening torque

Engine oil filter

Replace damaged parts or parts that have been dropped, even if there is no visual damage.

The engine oil filter is mounted on the engine oil heat exchanger, located behind the intake manifold, and is accessible by simply lifting the engine compartment lid.

The oil filter must be replaced at every oil change.

8. Screw the cap (1) back on tightly.

E3.12).

Undo the two drain plugs (1) on the crankcase and the plug (2) under the engine oil tank.

Drain the oil completely.

Engine oil filter cartridge

Class

-5

Table of Contents