Table of Contents
Advertisement
Water-engine oil heat exchanger
Undo the screws indicated by the black arrows.
Retrieve the bracket (1).
Undo the stud bolts (2) fastening the clamps (3).
Undo the screws indicated by the red arrows to
release the clamps (3).
Move the injection cable (4) away from over the
heat exchanger so that it does not hinder the
subsequent operations.
Move the engine services cable (7) out of the way
so that it does not hinder the subsequent
operations.
Remove the water vent pipe (8), undoing the
indicated union.
Undo all the screws indicated.
Mark the position of the screws, as they are not all
of the same length.
There may be residual engine oil inside the
heat exchanger.
Clean/dry any pooling oil/water.
Take particular care not to contaminate the two
systems.
Lift the oil-water heat exchanger (A) out of the
relative housing.
Page 2 of 5
Advertisement
Table of Contents
