Table of Contents
Advertisement
Axle shafts
Refit the rear flat undertray section (
Refit the rear bumper (
Refit the wheels (
D2.01).
Connect the DEIS diagnostic tester to the diagnostic socket (
Carry out the EPB Calibration procedure.
E3.12).
E3.04).
Left hand axle shaft
Press on the two indicated fastener tabs and fit the
left hand EPB Bowden cable sheath (9) into the
relative mounting bracket.
Attach the end (8) of the left hand EPB Bowden
cable (9) to the EPB linkage bracket.
Refit the clip (7) in the relative seat on the EPB
linkage bracket.
F2.10).
Page 6 of 6
Advertisement
Table of Contents
