Table of Contents
Advertisement
3.8 Replacing the subframe connector extruded section
9. Weld the suspension casting reinforcement to the
subframe connector extruded element and to the
upper external diagonal brace at the original weld
points.
Caution!
Remove the jig retaining the subframe connector
extruded element only after the welds have
cooled.
Apply new corrosion inhibitor to the entire repair
area.
10. Fit the external tower then mount the flank mounting
bracket (A) in the jig.
NOTE!
Check that the distance between the outer edge
of the bracket (A) and the sill wall is 115 mm.
Copyright ©
2010
9
115 mm
9
A
Advertisement
Table of Contents
