Table of Contents
Advertisement
Stabiliser bars - Tie-rods
Refitting the front stabiliser bar
Tightening torque
Fastening front stabiliser bar to chassis
Fastening rear stabiliser bar to tie-rod
Remove the stabiliser bar (A) from the chassis,
easing out from one side.
Screw
Nut
Apply 1 ml of DuPont Lubricants Krytox® 205
GPL Standard Grade Grease grease in a
uniform film over the entire inner surface and on
the lateral surfaces (contact surfaces only) of the
bushings.
Apply a uniform film of DuPont Lubricants
Krytox® 205 GPL Standard Grade Grease
grease to the outer diameter of the bar and the
shoulders of the bushings.
Fit the bushings in the relative seats on the
stabiliser bar, ensuring that the bushings are
oriented correctly (see notches on bushings).
Page 7 of 10
Nm
Class
30 Nm
B
50 Nm
B
Advertisement
Table of Contents
