Table of Contents
Advertisement
Brake pads
Refit the wheels (
D2.01).
Reconnect the battery (
In case of replacement only. Bed in the CCM pads (
Bedding in CCM pads
The following procedure is applicable for both CCM1 and CCM2 brake systems and must be performed EACH
TIME the CCM brake pads and/or CCM brake discs are replaced.
For vehicles intended for ROAD use
F2.01).
Fit the pads (A).
Install the pin (6), tapping with a suitable punch and
mallet.
Fit the spring (5).
Install the pin (4), tapping with a suitable punch and
mallet.
Fit new clamps as indicated to fasten the brake pad
wear sensor cable and fit the cable in the
retainers (2).
Connect the connector (1) for the brake pad wear
sensor.
D3.04).
Page 4 of 5
Advertisement
Table of Contents
