Table of Contents
Advertisement
Draining and filling with Shell Transaxle 75W-90 GL5 gear oil
Check the Shell Transaxle 75W-90 GL5 gear oil level (
Check that there is no leakage from the drain plugs.
Clean the plugs (1) and (2) thoroughly with a
suitable degreaser that does not leave residue,
and replace the seals.
Tighten the plugs (1) and (2).
Tightening torque
Plug
Undo the threaded inspection/filler plug (3) located
on the rear surface of the transmission.
Using the pump
(AV
8174) with attachment 01 (with
the short spout), aspirate the specified oil from a
newly opened container.
Using the pump
(AV
8174) element 01 and a
container for collecting excess oil, fill with 3.9
litres of oil via the inspection/filler orifice.
Fill with half of the quantity indicated, wait a few
minutes for the fluid to settle, then gradually
finish filling, until oil overflows from the
check/filler hole.
The quantity of oil required may vary slightly
relative to the amount indicated for filling the
tank when empty; this is due to unavoidable
pooling within the system. Fill gradually.
A3.02).
Page 2 of 2
Nm
Class
25 Nm
B
Advertisement
Table of Contents
