Table of Contents
Advertisement
Tyre pressure monitoring system
Refit the tyre (
D2.02).
Replacing front triggers
Tightening torque
Fastening trigger to mounting bracket
Disconnect the battery (
Remove the front wheelhouses (
Screw
F2.01).
E3.05).
Use a rod to ensure that the hole on the valve is
kept outside the rim.
Fit the rod (1) in the radial hole of the valve and
tighten the nut (2).
ALWAYS use a torque wrench, using only certified
and calibrated tools to ensure that the correct
tightening torque is achieved.
Tightening torque
Nut
Remove the rod (1).
For the sensor to function correctly, there must
be contact between the rim and the
mounting points of the sensor itself. The
system may not function correctly if the
sensor is not installed exactly as instructed.
Push the sensor gently onto the rim to ensure
contact between the rim and the mating surface
of the sensor itself.
Tighten the self-locking screw (5).
ALWAYS use a torque wrench, using only certified
and calibrated tools to ensure that the correct
tightening torque is achieved.
Tightening torque
Screw
Page 13 of 20
Nm
Class
4 Nm
A
Nm
Class
4 Nm
A
Nm
Class
9 Nm
B
Advertisement
Table of Contents
