Table of Contents
Advertisement
3.7 Replacing the fuel tank cross-member
7. Weld the fuel tank cross-member to the casting
joints on the rear sill pillars.
Caution!
Remove the jig retaining the fuel tank cross-
member only after the welds have cooled.
Apply new corrosion inhibitor to the entire repair
area and then apply a primer coat.
8. Fasten the mountings (A) to the fuel tank cross-
member with 8 M8 screws.
Caution!
Do not reuse the screws removed previously.
See paragraph (1.11.3 Screw connections).
Copyright ©
2010
7
7
7
8
A
8
Advertisement
Table of Contents
