Table of Contents
Advertisement
Complete suspension
Fit the union (12) for the brake fluid hose onto the
relevant mounting bracket.
Refit the clip (11) fastening the union (12) for the
brake fluid hose onto the relative mounting
bracket.
Tighten the brake fluid hose union (10).
Tightening torque
M10 union
Attach the cable grommet (6) onto the relative
mounting bracket.
Connect pad wear sensor connector (5), and attach
it to the relevant mounting bracket so as it is
pointing back.
Slide connector (4) of ABS sensor above brake pad
wear sensor cable, connect it, and attach it to
the relative mounting bracket.
Check that the indicated clip is positioned at 50 - 60
mm from cable grommet (6).
Connect ground cable to the indicated clip.
Connect the connector (3) to the shock absorber.
Page 11 of 25
Nm
Class
16 Nm
B
Advertisement
Table of Contents
