Table of Contents
Advertisement
Axle shafts
Tilt the hub carrier outward to detach the axle shaft from the differential flange.
If necessary, cut the cable retainer clamps to slacken any tension preventing the hub carrier from tilting.
Use a suitable punch and mallet to extract the axle shaft from the hub carrier bearing, then remove the axle
shaft from the vehicle.
Refitting the axle shaft
Tightening torque
Fastening upper arm to hub carrier
Fastening toe-in tie-rod to hub carrier
Fastening axle shaft to differential flange
Fastening axle shaft to wheel hub
When refitting the same axle shaft, remove any residue of AREXONS SYSTEM 56A01 - HIGH STRENGTH
RETAINING COMPOUND.
Remove any residue of AREXONS SYSTEM 56A01 - HIGH STRENGTH RETAINING COMPOUND from the
hub carrier bearing.
Check that the surface of the differential flange is completely clean.
Left hand axle shaft
Press on the two indicated fastener tabs and
remove the left hand EPB Bowden cable sheath
(9) from the relative mounting bracket.
Nut
Nut
Screw
Nut
Page 3 of 6
Nm
Class
90 Nm
A
80 Nm
A
78 Nm
A
275 Nm
A
Advertisement
Table of Contents
