Table of Contents
Advertisement
Pedal board
Refit the mats (
E4.05).
Reconnect the battery (
F2.01).
Place a 1 mm thick shim (4) between the brake
pedal (5) and the pin on the switch (A).
Release the brake pedal so that it presses against
the pin on the switch, allowing the pin to self-
adjust.
Remove the shim (4).
Connect the connector (2).
Fit the air duct (1).
Tighten the screws indicated.
Tightening torque
Screw
Page 5 of 5
Nm
Class
8 Nm
B
Advertisement
Table of Contents
