Table of Contents
Advertisement
Refitting the complete engine
Remove all the hoisting tools fitted previously.
Pretighten the nut (21).
Tightening torque
Nut
Tighten the nut (21).
Tightening torque
Nut
Use a feeler gauge to check that the gap between
the retainer bracket (44) and the engine
mounting bush (43), along the "X" axis, is
between 1.2 mm and 2.8 mm.
Use a feeler gauge to check that the gap between
the retainer bracket (44) and the engine
mounting bush (43), along the "Z axis, is
between 1.2 mm and 2.8 mm.
Fit and fasten the heat shields (37) over the engine
mounting bushes on both sides, tightening the
screws indicated.
Tightening torque
Screw
Page 23 of 30
Nm
Class
50 Nm
0
Nm
Class
100 Nm
B
Nm
Class
9 Nm
B
Advertisement
Table of Contents
