Table of Contents
Advertisement
ABS/ASR electrohydraulic unit
Detach the brake fluid pipes, removing the indicated
clips.
Detach the brake fluid pipes, removing the indicated
clips.
Disconnect the connector (2).
Take note of the pipes' position on the
electrohydraulic ABS/ASR unit (3) so as to refit
them correctly afterwards.
Undo all the unions indicated by the red arrows
from the electrohydraulic ABS/ASR unit and
place suitable plugs on the inlets.
Undo the indicated screws fastening the
electrohydraulic ABS/ASR unit mounting bracket
(3).
Move the brake fluid pipes to one side, taking
particular care not to bend or twist them, then
remove the electrohydraulic ABS/ASR unit (3)
complete with mounting bracket.
Page 2 of 4
Advertisement
Table of Contents
