Table of Contents
Advertisement
Fuel vapour separator
Refitting the fuel vapour separator
FROM Ass.ly No. 93334
Open the indicated studs.
Open the shielding (B).
Remove the indicated clamps fastening the pipe (7)
and disconnect the pipe from the active carbon
filter.
A "double-lock" safety clip (8) is fitted on the union.
To disconnect the "double-lock" quick connector,
using due caution and by pressing on both sides,
push the safety clip out of its seat until you hear
the "unclick".
The difference between the safety clip "clicked"
and "unclicked" position is only a few
millimetres.
Then press on both sides of the quick coupling and
remove the pipe (7).
Undo the screws (10) fastening the fuel vapour
separator (A) to the relative mounting bracket.
Remove the fuel vapour separator (A), complete
with pipes, from the engine compartment.
Fit the fuel vapour separator (A) in the relative seat
and fasten to the mounting bracket by tightening
the screws (10).
After connecting the quick connector pipe (7)
correctly to the active carbon filter, with due
caution and pressing on both sides of
the "double-lock" clip (8) indicated, push the clip
into its seat until it clicks audibly into place and
the pipe is fastened securely.
The difference between the safety clip "unclicked"
and "clicked" position is only a few millimetres.
Fasten the pipe (7) with the indicated clamps.
Page 2 of 3
Advertisement
Table of Contents
