3.3 Configuring System Management With Cli; Saving Configurations; Table 4 Priority During Database Corruption Recovery - Nokia 7302 Basics, Management And Oam Manual

System Management
Table 4
After executing the oam-save-protected command and activating the
default-database, nt-b will come up as "peer-not-plan". Management that was
connected with nt-b active or a hotstandby port, is now lost since the equipment
related configuration (i.e. "peer-plan") was not saved. However, management will
resume once nt-b is planned, because the configuration is retained.
Regardless of whether the oam-save-protected command is executed or not, if a
switch-over is performed on a protected interface, the protected configuration will be
synched with the standby. After the switch-over, protected configuration is available.

3.3 Configuring System Management with CLI

3.3.1
Whenever configuration changes are made, the modified configuration must be
saved so the changes will not be lost when the system is rebooted.
26
Priority during database corruption recovery
On a Shelf-restart
Configuration Database
corruption
Configuration Database
corruption
Configuration Database
corruption
Configuration Database
corruption
Configuration Database -
Ok
Configuration Database -
Ok
Configuration Database -
Ok
Configuration Database -
Ok
If an interface is protected and OAM save protected is
Note —
executed but instead of default DB if the system is rebooted, its
behavior will be same as before the introduction of this feature.

Saving Configurations

3HH-11982-AAAA-TQZZA
"FD 100/320Gbps NT and FX NT IHub System
Special protected OAM protected
Database database
Present and Present and
no-corruption no-corruption
Not-present/Corrupt Present and
no-corruption
Present and Not-present/Corrupt
no-corruption
Not-present/Corrupt Not-present/Corrupt
Present and Present and
no-corruption no-corruption
Present and Not-present/Corrupt
no-corruption
Not-present/Corrupt Present and
no-corruption
Not-present/Corrupt Not-present/Corrupt
Basics, Management and OAM Guide"
Configuration Restored
From OAM protected
database
From OAM protected
database
From Special protected
database
Default/Empty
configuration
From Configured/Saved
database
From Configured/Saved
database
From Configured/Saved
database
From Configured/Saved
database
Issue: 10