Connecting The Power Cord; Connecting The Digital I/O - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

UltiMate 3000 Series:
TCC-3000SD and TCC-3000RS Column Compartments

3.4.3 Connecting the Power Cord

Use the power cord shipped with the pump to connect the instrument to the main power
source. Connect the power cord from the main power receptacle on the rear panel (→ Fig.
2, page 19) to a grounded power source. No manual adjustment is required to adapt the
line voltage to local voltage requirements.
Warning:
Avertissement: Utilisez uniquement les cordons d'alimentation électrique spécifique

3.4.4 Connecting the Digital I/O

To connect an external device to a digital I/O port, use the appropriate 6-pin mini-DIN
cable (part no. 6000.1004).
1. Plug the 6-pin connector of the mini-DIN cable into the Digital I/O port 1 (or 2). For
information about the functions of the connector pins and pin assignment, see
page 125.
2. For each relay output or digital input to be used, connect the appropriate signal wire
and ground wire to the corresponding connectors on the external device
(→ documentation provided with the external device).
3. When configuring the TCC in the Chromeleon Server Configuration program, make
the following settings:
On the Relays page, select the corresponding relay output (→ page 43).
•
On the Inputs page, select the corresponding digital input (→ page 43).
•
Page 34
Never use a power cord other than the power cords provided for the
device.
Do not use multiple sockets or extension cords. Using defective
multiple sockets or extension cords may cause personal injury or
damage to the device.
à l'instrument.
N'utilisez pas des blocs multiprise ou des câbles prolongateurs. Cela
pourrait entraîner des blessures corporelles ou endommager
l'instrument.
Operating Instructions