Operation From Chromeleon; Connecting To Chromeleon - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

5.3 Operation from Chromeleon

Before you begin, verify that
1. The Chromeleon software is installed on the computer and the license code is entered.
2. The TCC is connected to the Chromeleon computer by means of a USB connection.
Tip: Verify that Chromeleon is installed on the computer and that the license
code is entered before you connect the TCC to the USB port on the
Chromeleon computer and turn on the TCC power. Only then, the USB
driver for the TCC is automatically loaded and the Windows operating
system can detect the TCC when the power is turned on.
3. The TCC is set up in Chromeleon, as described in section 3.5 (→ page 35).
Before you can operate the TCC from Chromeleon, you have to connect the timebase in
which the TCC is installed to the Chromeleon client program (→ section 5.3.1).
Two modes of software control are available:
Direct control with the parameters and commands in the Commands dialog box
•
(→ page 62) or on a control panel (→ page 63).
Automated control with a control program (PGM) (→ page 65).
•

5.3.1 Connecting to Chromeleon

1. Start the Chromeleon Server Monitor and the Chromeleon server if they are not yet
running (→ page 35).
2. Start the Chromeleon client by clicking the Chromeleon icon
If the Chromeleon icon is not on the desktop, click Start on the taskbar, point to
Programs (or All Programs, depending on the operating system), point to Chromeleon,
and then click Chromeleon.
3. Connect the Chromeleon client program to the timebase in which the TCC is installed.
For details about how to do this from the Commands dialog box, see page 62. For
details about how to do this on a control panel, see page 63.
Operating Instructions
TCC-3000SD and TCC-3000RS Column Compartments
UltiMate 3000 Series:
on the desktop.
Page 61