Making the Initial Back Panel Connections
Connecting the Ethernet Cable
Thermo Scientific
Use the Ethernet and interconnect cables provided with the detector to make the back panel
connections described in this section.
This section contains the following topics:
•
Connecting the Ethernet Cable
•
Connecting the System Interconnect Cable
To connect the Ethernet cable
1. Connect one end of the Ethernet cable supplied in the accessory kit for the RI detector to
the Ethernet port located on the back of the detector as shown in
2. Connect the other end of the Ethernet cable to an Ethernet switch.
Figure 10. Ethernet connections
8-pin receptacle for the
interconnect cable
Computer
USB
ENET
Ethernet box
Solvent platform
RI detector
Autosampler
LC pump
Surveyor RI Plus Detector Hardware Manual
2
Installation
Making the Initial Back Panel Connections
Figure
10.
Ethernet port
CAT5 shielded
Ethernet cables
15