Making The Back Panel Connections; Connecting The Ethernet Cable; Connecting The Interconnect Cable - Thermo Scientific Surveyor PDA Plus Hardware Manual

Making the Back Panel Connections

Connecting the Ethernet Cable

Connecting the Interconnect Cable

Thermo Scientific
Use the cables provided in the Surveyor system accessory kit to make the connections to the
back panel of the detector. The part numbers for these cables are listed in
page 104.
See "Turning On the Detector for the First Time"
to line power.
This section contains the following topics:
• Connecting the Ethernet Cable
• Connecting the Interconnect Cable
• Connecting the Analog Outputs
• Setting the Analog Output Voltage
• Setting the Unit ID
Connect the Ethernet switch to the Ethernet connector port of the PDA detector using the
supplied CAT5, 7 ft. long, shielded Ethernet cable with ferrite clamp.
The interconnect cable coordinates the timing of the Surveyor Plus modules during an
injection sequence. There are two versions of this cable. The previous version of the cable,
which you might have in your laboratory, contains five connectors labeled as follows: DET,
M/S, A/S, LC PUMP, and MS PUMP.
cable, which contains the following: three detector connectors labeled DETECTOR, two
pump connectors labeled PUMP, an autosampler connector, and an MS detector connector.
Figure 9. Seven-connector version of the system interconnect cable
M/S
Autosampler
connector
on page 19 for instructions on connecting
Figure 9 shows the new version of the interconnect
A/S
Surveyor PDA Plus Detector Hardware Manual
2
Installation
Making the Back Panel Connections
Table 6 on
11