Special Chromeleon Functions; Ready Temp Delta And Equilibration Time - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

UltiMate 3000 Series:
TCC-3000SD and TCC-3000RS Column Compartments

5.6 Special Chromeleon Functions

This section provides a short overview of some special functions that Chromeleon supports
for the TCC.
To learn more about ...
Equilibration Time and Ready Temp Delta
Predictive performance
Diagnostics
Recording the temperature signals
Operational Qualification and Performance Qualification
All of these functions are available in the Commands dialog box (unless otherwise noted).
In addition, some functions are available also on the control panel for the TCC. For
additional information about a function, see the Chromeleon Help.

5.6.1 Ready Temp Delta and Equilibration Time

The Ready property indicates whether the TCC is ready for operation. When the TCC is in
the status NotReady, you cannot start the analysis.
Keep in mind that the settings for Ready Temp Delta and Equilibration Time influence the
time that the TCC needs to enter the Ready state:
Setting
ReadyTempDelta
Page 80
Description
Indicates for how much degrees the current temperature may be above or
below the temperature set point.
If the current temperature deviates from the temperature set point by more
degrees than the value entered here, the TCC enters the NotReady state and
is not ready for operation.
Example:
Temperature set point: 45 °C, ReadyTempDelta: 1 °C
The TCC is ready for operation when the current temperature is between
44 °C and 46 °C. If the current temperature is outside this range, the TCC
enters the NotReady state.
If ReadyTempDelta is set to None, Chromeleon does not check whether the
current temperature deviates from the temperature set point.
See page ...
See below.
82
83
83
83
Operating Instructions