Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual page 78

UltiMate 3000 Series:
TCC-3000SD and TCC-3000RS Column Compartments
5.4.2.2 Main Menu
The Main menu provides top-level access to the menu structure. To open the Main menu,
show the function keys and select Menu (→ page 67).
• Control
On the Control menu, you can make the different settings for TCC operation
(→ page 70).
• Information
The Information menu provides information for diagnostic purposes (→ page 71).
• Configuration
The Configuration menu provides information about the TCC configuration and allows
you to make the required settings or perform the related commands (→ page 71).
5.4.2.3 Control Menu
On the Control menu, you can make the settings for temperature control and valve control. In
addition, you can activate leak detection and specify the sensitivity of the gas and humidity
sensors.
To ...
Set the setpoint temperature for thermostatting and turn thermostatting on or
off.
To do so, select Compartment and Compartment control for column
thermostatting.
TCC-3000RS: For post-column thermostatting, select Post-cooler and Post-
cooler control.
Determine the switching position of the valve (= the fluid connections
through the valve).
Determine whether leak detection is performed and how you are alerted in
case of an alarm. Select the sensor and set the sensitivity:
low, standard, or high—turns leak detection on and sets the sensitivity with
which the sensors respond to excessive gas or humidity. When a sensor is
activated, a message appears on the TCC display and a beep sounds.
low silent, standard silent, or high silent—turns leak detection on and sets
the sensitivity with which the sensors respond to gas or humidity. When a
sensor is activated, a message appears on the TCC display, but no a beep
sounds.
off—turns leak detection off.
Page 70
Select ...
Temperature
Valve
Leak
Operating Instructions