UltiMate 3000 Series:
TCC-3000SD and TCC-3000RS Column Compartments
Configuration Page
Use this page to determine whether Chromeleon shall record the temperature signals as
separate channels and select the pressure unit.
Temperature Signal
•
The check box is selected by default. Accept this setting if you want to record the
temperature of the TCC as a separate channel (→ page 83).
The name under which temperature signal is identified in the installation environment
and in the Chromeleon client is ColumnOven_Temp. Accept the default name. If you
enter a different name, you may have to re-link the controls on the control panels.
•
Cooler Temp. Signal (only TCC-3000RS)
The check box is selected by default. Accept this setting if you want to record the
temperature of the post-column cooler as a separate channel (→ page 83). The signal will
be recorded only if you have also selected the post-column cooler check box on the
Components page (→ page 39). Accept the default name (Cooler_Temp) under which
this temperature signal is identified in the installation environment and in the
Chromeleon client. If you change the default name, you may have to re-link the
corresponding controls of the related control panels.
Pressure Unit
•
Select the pressure unit to be used for storing the pressure values on the column ID chip
card.
Rear Temperature
•
The check box is selected by default. Accept this setting. The signal will be recorded as a
separate channel. If a problem occurs, the channels can provide helpful information to
identify and eliminate the source for the problem.
Page 42
Fig. 12: Configuration page (here TCC-3000RS)
Operating Instructions